Massa M3 Manuale Utente Scaricare il pdf (Pagina 21)

MASSA PRODUCTS CORPORATION June 11, 2013

Product Manual 20 M3 Wireless Ultrasonic Level Sensor

13) Reboot the gateway to have the settings

take affect by selecting Administration

Reboot, then click on the Reboot button.

This will take approximately 1 minute.

14) Verify if the Python code is active by

entering the Management Connections

menu. If the python code

Python:massa_gateway_appl.py does not

appear under the title Protocol, then you

may have to reboot again or check to see if

is it enabled in the Auto-start Settings

menu as seen on Step 12.

15) Turn on the M3 Sensor and wait for it to

associate itself to the gateway (brief flash

every 2 seconds). If it does not associate,

press the sensor’s Commission button

once. Click on the Configuration XBee

Network menu and press the Refresh

button to see the sensor on the device list.

Once you have established the sensor on

the ZigBee network, you can proceed to

installing the M3 Application Software,

see next page. Note that the Node ID will

indicate sensor model type (from the

XBee’s NI register).

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28 29

Nessun commento

Massa M3 Manuale Utente Pagina 21